This double cardan style CV drive shaft is recommended for Jeep TJ Rubicon models equipped with 4in - 6in suspension lifts to prevent driveline vibration and the rear output shaft from breaking.

This drive shaft will flex to a nominal 30 degrees prior to binding and is a direct bolt in replacement that Does Not Require removing the factory original out-put mass vibration dampener hub.

It is built on a 2.5in tube diameter and uses the stock 1330 sized universal joint at the rear differential end and a massive 1350 CV head.

Features:

• Collapsed Measurement: 16. 875-inches
• Extended Measurement: 20. 125-inches
• After lifting your Jeep TJ Wrangler a CV (Double Cardan) drive shaft is a good choice to eliminate vibration issues and provide the longest lasting drive shaft.
• Flexes to a nominal 30 degrees prior to binding.
• Direct bolt-in replacement.
• Does Not Require removing the factory original out-put mass vibration dampener hub.
• Includes better quality CV joints.
• Features massive 1350 CV head.
• Shaft strength is twice as strong as the factory equipped drive shaft.
• Grease fittings are out of the way of the transmission oil pan meaning you get grease to the joints that need it and Not all over the botom of your Jeep.

Notes: Only fits 03-06 Rubicon models. Recommended on models with 4in - 6in of lift.

Details:

• Sold As Each
• Location Rear
• Drive 4WD
• Extended Length 20.125 inch
• Collapsed Length 16.875 inch