Badlands

DYNAMIC: Once turn signal is pressed, the LED's running lights on that side will shut off, then begin to flash from off state to bright, turn signal state before starting the sequence over

Provides running light, brake light and turn signal functions to the rear turn signals. This module also has a built-in Load Equalizer to prevent rapid flashing turn signals.

Provides running light, brake light and turn signal functions to the rear turn signals. This module also has a built-in Load Equalizer to prevent rapid flashing turn signals.

Simple hard-wire design that works with most Badlands modules.

If room is an issue, (custom bike applications) the IHL-03 will perform the same functions of the IHL-02 but are only rated for 500 milli-AMP maximum.

Works for taillights, signals, marker lights, rear fender tip, neon accent lighting or (two) 25-Watt driving lights

Works for taillights, signals, marker lights, rear fender tip, neon accent lighting or (two) 25-Watt driving lights

Converts rear turn signals into running lights, brake lights and turn signals

Converts rear turn signals into running lights, brake lights and turn signals

Converts rear turn signals into running lights, brake lights and turn signals

Front run and turn signal for single-filament bulbs, halogen bulbs and LEDs Rear run, brake and turn signal functions like the Illuminator module

Designed to prevent rapid flashing turn signals. This module will produce heat and it is not intended for extended usage in 4-way flasher mode.