Camburg

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...

This is the hardware kit included with our 3.50 axle housing for the 3rd member. These thread in from the backside then the nut tightens down on the case. We don't use gaskets between the housing and...

This is the drain plug kit we use in our Camburg 3.50 and 4.00" axle housings but can be used for many different things. You can either MIG or TIG weld the steel bung on and then thread in the zinc...

Looking to replace the outer uniball bolts on your Camburg lower control arms? This kit comes with two 3/4” grade 8 hex bolts and the necessary grade 8 washers and stover lock nuts.This Part...

Looking to replace the outer uniball bolts on your Camburg lower control arms? This kit comes with two 3/4” grade 8 hex bolts and the necessary grade 8 washers and stover lock nuts.This Part...

Enhance your off-road fabrication projects with the Camburg 0.75" 4130 Weld Washers (4pk). These washers are a must-have for any suspension system upgrade or custom fabrication endeavor, offering...

Our Camburg threaded bungs are machined in-house from aircraft quality 4130 chromoly, not cheap mild steel or imported low quality material. These are a stepped design to match the OD of the tubing...

Our Camburg threaded bungs are machined in-house from aircraft quality 4130 chromoly, not cheap mild steel or imported low quality material. These are a stepped design to match the OD of the tubing...

Our Camburg threaded bungs are machined in-house from aircraft quality 4130 chromoly, not cheap mild steel or imported low quality material. These are a stepped design to match the OD of the tubing...

Our high mis-alignment spacers are CNC machined in-house from heat-treated stainless steel and are available in an assortment of sizes for different heims and uniballs. Our design maximizes strength...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...