Fabrication

Edelbrock part #8117 heater hose end is designed to hold up to any plumbing task you have. This heater hose end is made from high quality aluminum to ensure they won't rust or corrode. Features Straight end with 3/8" NPT and 3/8" Barb, black anodized...

Edelbrock part #8115 heater hose end is designed to hold up to any plumbing task you have. This heater hose end is made from high quality aluminum to ensure they won't rust or corrode. Features Straight end with 3/8" NPT and 1/2" Barb, clear anodized...

Edelbrock part #8114 heater hose end is designed to hold up to any plumbing task you have. This heater hose end is made from high quality aluminum to ensure they won't rust or corrode. Features Straight end with 3/8" NPT and 1/2" Barb, black anodized...

Edelbrock VRS-4150 Carburetor Dual-Inlet Fuel Line Kit

This Edelbrock Fuel Line Kit #8101 is temperature, gas and oil resistant. This kit is made from reinforced synthetic Chlorinated Polyethylene rubber hose with a nylon inner braid for strength. Features a -6 AN inlet fitting and a 1/8" pipe fitting with...

Edelbrock part #8096 Vacuum Adapter Fitting is a low profile elbow that is designed to provide clearance for Holley and other carbs with a rear fuel bowl that extends over the vacuum port tap in most intake manifolds. Machined from solid brass.Warranty

The Edelbrock ProClassic Fuel Hose Kit #80913 supplies fuel to two Edelbrock carbs when used on Edelbrock Dual-Quad manifolds. Use with a fuel hose kit such as our #8122 or #8127. 6-7/16" center-to-center, 1/8"-NPT fuel pressure port and a 3/8"-NPT fuel...

Edelbrock part #8090 Inverted Flare (3/8) Fuel Fitting for Edelbrock Square-Bore & AFB Carbs. The fitting comes with a sealing washer and has 5/8-20 threads. This fitting is standard on the E.P.S. marine carburetors, 1409 and 1410.Warranty

Edelbrock part #8089 Banjo Fitting is designed for Edelbrock Square-Bore & Carter AFB Carburetors.Warranty

The Edelbrock Fuel Hose Kit #8088 supplies fuel to two Edelbrock carbs when used on Edelbrock Dual-Quad manifolds. Use with a fuel hose kit such as our #8122 or #8127. 6-7/16" center-to-center, 1/8"-NPT fuel pressure port and a 3/8"-NPT fuel inlet...

Edelbrock part #8087 is a -6AN x 5/8"-20 Fuel Inlet Fitting for Edelbrock Square-Bore & Carter AFB Carbs. This fuel inlet fitting is designed to replace the EPS carburetor's existing fuel inlet fitting, allowing the use of braided fuel line.Warranty

Edelbrock part #8080 Brass Hose Fitting is a 1/4-18" NPT fitting with a 3/8" barb. This Fitting will fit the rear vacuum port of all Edelbrock four-barrel carbs.Warranty