Fabrication

Our system does away with two potential boost leak points thanks to our single cast design. We've upgraded the factory rubber intercooler outlet hose to a multi-ply wire-reinforced silicone design...

Thin-wall aluminum construction maximizes the internal diameter without compromising strength, while bead-rolled pipe ends prevent hose slippage under boost. TIG-welded brackets and a billet-aluminum...

The factory plastic and rubber turbo outlet pipe is a small and restrictive 38mm pipe that has shown to melt, deform, and cause boost leaks under extreme conditions. The APR System remedies this by...

The APR Turbo Inlet Pipe is an easy-to-install bolt-on upgrade that eliminates a restriction before the turbocharger. Unlike fabricated units on the market today, ours is cast from aluminum, allowing...

APR's 2-Piece Design Explained: As is true with all machined parts, it's impossible to make all parts the same. In the case of the turbo muffler housing, the distance between the bottom and top of...

Cast from T304 Stainless Steel, the splitter allows for easy connection to a 76mm (3") pipe and splits at 90 degrees to a dual 63.5mm (2.5") pipe. Your exhaust pipes simply butts up to the...

Cast from T304 Stainless Steel, the splitter allows for easy connection to a 70mm (2.75") pipe and splits to a dual 63.5mm (2.5") pipe. On each end the pipe is CNC-machined creating a clean and flush...

Cast from T304 Stainless Steel, the splitter allows for easy connection to a 76mm (3") pipe and splits to a quad 63.5mm (2.5") pipe. Your exhaust pipes simply butts up to the CNC-machined section of...

Cast from T304 Stainless Steel, the splitter allows for easy connection to a 76mm (3") pipe and splits at 150 deg to a dual 63.5mm (2.5") pipe. Your exhaust pipes simply butts up to the CNC-machined...

For the DIY customers looking to adapt our inlet system to other intake setups, we offer the Carbon Fiber Back Tube and Cast Aluminum Turbo Inlet separately. Please note, this may require special...

The APR Turbocharger Inlet System outflows the factory components by up to 45%, and jumps to 60% when adding the APR Intake Filter. This is firstly achieved through elimination of the most critical...

Ridetech rear 3.5"-5.5" lowering kit with Adv. Series Shocks for 2015-2026 F-150. Includes shocks, axle flip brackets, leaf spring brackets, shackles, bump stops and hardware.