Forced Induction

Direct bolt-on replacement 3" to 2.75" cold-side intercooler pipe in wrinkle black finish Eliminates the crumpled section of the OEM intercooler pipe which restricts airflow from the intercoo

Direct bolt-on replacement - no modification required 85 degree reduction in Charge Air Temperature observed in real-world conditions (charts below) 214% greater volume and 260% gr

35+ degree reduction in Charge Air Temperature (IAT2) observed in real-world conditions (details in chart below) Direct bolt-on replacement (trimming of plastic shroud is required) 24 x

Will not activate check engine light T304 stainless steel 3" diameter High-flow 500 CPSI catalytic converters

Gains of 26HP and 32TQ observed in test runs Increase in cross sectional area at the bottle-necked section of the stock tubes Metal inserts at 4 clamp points prevent crumpling under performan

Includes 2x 8 inch, 8-layer CVF dry filters Dual intake aluminum tube design with an H-pipe to balance pressure and maximize air flow / velocity Outflows factory intake by 35%<

Includes 2x 8 inch, 8-layer CVF dry filters Dual intake aluminum tube design with an H-pipe to balance pressure and maximize air flow / velocity Outflows factory intake by 35%<

NEW! Revised design will not activate check engine light 140% increase in cross sectional area at the bottle-necked section of the stock tubes Metal inserts at 4 clamp points prevent crumpling...

+20 HP gain using inlet tubes and tuning alone 222% increase in cross sectional area at the bottle-necked section of the stock tubes Metal inserts at 4 clamp points prevent crumpling un

200% increase in cross sectional area at the bottle-necked section of the stock tubes Metal inserts at 4 clamp points prevent crumpling under performance temps. Includes upgraded T-bolt clamps...

2.3125" ID outlet for greater exhaust throughput (OEM is 2.0625") Direct bolt-on to factory or aftermarket turbos that utilize stock adapters Fits both OEM and aftermarket turbos and exhausts

Outflows OEM piping by 11% (cold side) and 16% (hot side) Includes 1/8th NPT bungs for water/meth injection or sensors (both sides) Made from 3.5" to 2.75" (cold side) and 2" to 2.5" (hot sid