Additives

To prepare, attach tube with nozzle. To gain access, remove hose or pipe immediately before throttle housing. The engine needs to run to perform cleaning. If unable to start engine, disconnect air mass sensor connector while the ignition switch is in off...

Can contents (300 ml) are sufficient for up to5 liters (5.28 U.S. QT)of motor oil. After adding to the motor oil, allow the engine to run warm. The product can be added at any time. Minimum oil filling of 3 liters (3.17 U.S. QT) is requested for optimum...

Contents sufficient for max. 5 liters (5.28 U.S. QT) of motor oil, minimum filling of 3 liters (3.17 U.S QT) is requested for optimum product performance. The product is self mixing and can be added at any time, sealing first takes effect after about...

One 80 ml can is sufficient for 1-2 liters(0.25-0.5 gal.) of oil. Add Motorbike Engine Flush Shooter to the motor oil at running temperature before changing the oil. After adding the product, allow the engine to idle for approx. 10 minutes. Then change...

LIQUI MOLY recommends adding Motorbike Radiator Cleaner to the cooling water if problems arise or before changing the coolant. Depending on the level of contamination, run the engine at operating temperature for 10-30 minutes. Drain the cleaner and flush...

Aunique, state-of-the-art combination of acceleration-enhancing, cleaning, dispersing and material-protecting additives. Easy engine start, smoother running and better throttle response are the effects.Installation InstructionsMaterial Safety Data Sheet

Will immediately seal small leaks caused by external damage, porous solder joints and hairline cracks in cooling systems of all water cooled engines. Coolant is prevented from entering the combustion chamber due to internal leaks from head gasket etc. It...

Cleaning is made with the compressed air gun for DPF (item no. 7946) and the specially developed DPF-Probe with 5 interchangeable tips (part no. 7945). The diesel particle filter must be accessed depending on the vehicle type. In order to do this, the...

Cleaning is made with the compressed air gun for DPF (part no. 7946) and the specially developed DPF-Probe with 5 interchangeable tips (part no. 7945) or the DPF spray Probe long (part no. 20630). The diesel particle filter must be accessed depending on...

Add into the fuel tank. For optimum effect, add every time you refuel. Fully compatible with all grades of gasoline fuel. Contents of can are sufficient to treat up to 20 liters (5.2 gal.) of fuel. Minimum fuel filling of 15 liters (4 gal.) is requested...

Filling the dosage chamber (25 ml) once is sufficient for max. 5 liters (1.3 gal.) of fuel. Add to the fuel and repeat dosage after refueling. Also suitable for long-term use in seldom used engines. When decommissioning, add to the fuel and let the...

Preventive use Fill the fuel filter up with Diesel Purge when doing filter replacement, put the rest in tank. Remedial use Unclip the fuel pipe and immerse the end in the Diesel Purge. Close the fuel return pipe or feed that into the Diesel Purge. Start...