SPC Performance

This easy to install full contact shim is specifically designed for the Internationl models of the Honda Civic Type R. The specific regions include the following years: European (2007-2008) and Asian...

These full contact rear shims will correct camber and/or toe. Combination adjustments, or changes up to 1 degree may be achieved by using 2 shims on each wheel. NOTE: Do NOT adjust Camber or Toe over...

This full contact rear shim adds positive 0.75deg camber to minimize camber related tire wear for 08-09 Ford Taurus and 05-07 Ford Freestyle FWD. Brake Caliper shim included for correct hub to...

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding...

Often called "dimple dies", flared hole dies are used in sheet-metal fabrications to provide rigidity and strength to flat, unsupported panels. Due to the resulting high strength -to-weight ratio...

For camber and toe change, use our Mini-Van Shims that allow for quick and easy changes in increments of: toe .10 degrees and camber .25 degrees. CAUTION:check brake and rotor clearance for binding...

Change camber,caster or both at the same time with these sleeves. Simply remove the tire, cotter pin and upper ball joint stud nut and break the taper free between the stud and sleeve. Using a sleeve...

These popular sleeves are widely used to adjust caster and/ or camber on many Ford and Mazda RWD & 4WD trucks. To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring...

This sleeve will easily change Camber and/or Caster 0.00° for vehicles equipped with twin traction beam DANA 44 axles. Simply remove the tire, cotter pin and upper ball joint stud nut and break the...

This sleeve will easily change Camber and/or Caster 0.00° on Ford Heavy Duty trucks. These sleeves are designed for Ford F250 and F350 Super Duty truck applications. Use the (23229) zero-degree...

This sleeve will easily change Camber and/or Caster 0.00° on Ford F450 and F550 Super Duty trucks with Dana Super 60 solid axles. Use the (23239) zero-degree sleeve to determine the amount of change...

These high strength forged rear arms are perfect for tuners or installers that need extended camber ranges on these popular platforms. Complete with O.E. stype bushings installed for a factory type...